The high idle can be caused by a back throttle position sensor or Idle air control.

It broke about 6 inches from where it goes on to the shock.

So I just need to put both ends of the line into that connector and close it and it's good to go?

Thanks for the great idea!

I recently noticed that one of my air lines is broken on my 2000 SE. has anyone replaced these lines before? If so where can I find them?

I may have seen this car driving around recently.

Over the past few days the blower motor on my 97 Olds 88 will intermittently not work and will not make any sounds. If I tap on the dashboard it will come right on and all speeds will properly work. Would this most likely be a bad blower motor?

Just looking for something with good sound.

What would be a good replacement speaker?

How do I remove the rear speakers to replace them with new ones, do they come out through the trunk? Also what size are the factory speakers? Thanks

My 97 Olds 88 keeps wearing out the left front trans mount. Has anyone figured out a solution to this?

I'm Looking to do a complete engine and trans swap along with the pcm from a 98+ W body. in terms of wiring, what do I need to modify to make my currents electronics work? Thanks

There was a discussion a while back on how to restore operation to the fuel gauge on the 00+ models. What was the part number of the fuel level sensor? Thanks

Does anyone have advice on how to replace the steering shaft that goes between the column and the rack and pinion? Tried to replace the shaft and absolutely can not get the shaft to slide back on to the shaft coming out of the column. I'm just wondering if the column needs to be removed in order to ...

I just purchased a Moog outer tie rod for my 00 SE and I am rather confused as to where the washer that was included goes. Has anyone installed this part on their car? Thanks

I have a vacuum leak in the tube that goes from the EGR to the intake manifold where the metal outlet line joins the EGR. Does the intake need to come off to change this tube? Also could I use RTV to seal up this vacuum leak as a temp fix?

Is this solenoid supposed to be constantly clicking and pulsing while the engine is running?

The 9011 is the high beam correct?

I'm looking to convert my high beams on my 97 Olds 88 from 9005 to 9011 bulbs. Do I heed to modify anything else other than the one tab on the bulb? Thanks.

https://www.youtube.com/watch?v=n6LMkjwsQ4s This guy used a series 1.