A little while ago, I posted a question here about a crank, no start problem I had with my 2005 SE.
I did all the tests and diagnosed it as a failed crank position sensor. Turns out I don’t have the tools necessary to do the job. (Couldn’t break the vibration damper bolt loose) and took it to a ...

Discovered the problem, bad crankshaft position sensor.

My wife’s 2005 SE was running fine. Went out to go to work next night and the car won’t start. Turns over just fine. Has 55psi of fuel pressure. Has spark at all the plugs. Nothing blocking air intake. No trouble codes. Can see the valves from the oil fill cap moving. What can the problem be?

Is replacing it doable by me or does it require something special to bleed the brake system afterwards?

My 2005 SE has a braking issue I don't quite understand. When slowing down to a stop and I lessen the pressure on the brake pedal to make a nice smooth stop the pedal falls away so that it's just above the floor. If just slowing down for traffic, the pedal does the same thing, but if I lift ...

Think I know what my problem is, but I just want to see if I'm on the right track and if there is anything I might be missing.
The air output on my 01 SSEi will only blow out of the dash panel vents. Won't change to floor, defrost or anything else. If I press the Auto button, it appears to be on ...

I've been reading through earlier posts to diagnose what is happening with my Bonny, and I just want to confirm with all of you what is the problem and how to fix it.
My 2001 SSEi A/C only blows out of the panel vents. Will not change to floor, or to the windshield. Air mix actuator, correct ...

What could be the cause of my 2001 SSEi having hard steering (no power assist) only when turning right? Turning left is fine, and every once in a while when turning right it works fine. Is it the pump, the steering rack or something else? I've been putting up with this for quite a while, and I'm ...

My Bonny has developed a strange steering problem.
Turns to the right are very stiff, feels like no power assist. Turns to the left are fine.
Checked the P/S fluid, and is very slightly low, but not enough to really make a diff.
Yesterday when it was a little rainy and damp here, worked fine in both ...

If it's the wires, why would it be throwing a code for the EGR flow?
If it's possibly a plugged cat, would it still be able to rev up normally in neutral (4000 rpm) with no stumble or miss?

Just put in new NGK TR-55's about a month ago. But didn't do the wires.

For a couple of weeks, car has had almost no power.
If I'm light on the gas, will accelerate normally.
If I drive normally, right at 2300rpm the engine feels like it's cutting out/missing and the SES light comes on blinking.
When I let off, after a few seconds to a minute the SES light goes out ...

I'm with harofreak00 on this. The fix works great.
For less than $10 bucks and about an hour to make the part, fixes the prob and it WON'T happen again

Have been getting the P0401 code intermittently for a couple weeks now.
If I'm really light on the gas from a stop the engine runs smoothly and no SES light.
If I drive normally or really step on it, it has no power, acts like it's missing, and the SES light blinks.
Soon as I let off and cruise, SES ...

Just changed the stock 195 stat to a 180, yet the car still seems to be running at the same temp.
Gauge needle is just a tiny fraction past the 200 degree mark. Radiator is full, and overflow tank is also to Full Hot line.
Shouldn't the gauge now be at least 1 full mark under the 200?
What could be ...

It's ironic that I have to do something like this for my 2001 Bonny.
I've had to do something like this for my '63 Studebaker GT Hawk.
The original front mounts, while not liquid filled like the Bonny's, I kept destroying.
They were solid rubber, but with steel plates molded in on each end.
During ...