Sorry about that, my service engine light is on because of the removed relays. It doesn't come back on when I reinsert the relays

No no pending codes. Only my p0442 code if I remember correctly. The only thing I could think of is the way I wired my alarms remote start to the 2nd acc wire. I was trying to have the heat come on while its started remotely. I don't know exactly when this problem started and I don't know if any of ...

Anyone?

Well so far Ic checked for codes and nothing. I played with fan relays sp I think, hi, and low. When removed the fans turn off respectively and the sp relay keeps it from coming on completely.
I believe I do need a new thermostat because all through winter the car never warmed to operating temps not ...

I remembers a long time ago that there was a fan switch override on the series 1 motor. Since I can't figure out why my rad fans stay on during start up to shutdown I was wondering if it's possible to do it on the series 2 motor, specifically my PA Ultra.

Has anyone ever cut the flange off the flexpipe (stock downpipe) and considered welding it to an aftermarket DP? From what I see it could create some what of a bottle neck before entering the pipe as the flange is doubled walled, but will it hurt or be the same as running a stock flexpipe (downpipe ...

Well I found out that a regular vacuum line won't last from the fuel vapors and such so its best to use fuel hose.

I think the vent valve which is located on the canister. Mines is in the rear. I was just going to go to the by and swap out the valve to see if it corrects the problem

Yes it's rusted along with a p0442 code. So I was going to replace the line along with the valve

I'm going to replace the line going from the engine bay to the evap canister in the rear of the vehicle. Since it is just a vac line would it be safe to use vacuum hose alone with a steel line?

Ok I can't get my idatalink (solo- ads-alsl-gm) to function properly it keeps flashing red even when I factory reset. I didn't connect any wires to the passkey as the diagram shows not to, idk. So I'm going to wire my alarm in the old hard way. There is a xpresskit bypass already installed for ...

Ok thanks

Anyone?

I have acquired a 2000 Buick Park Ave Ultra which has a torn cv boot on the driver's side and there's grease everywhere. I'm about ready to tackle as I have the replacement axle cardone 661444. I notice the axle didn't come with a abs ring do I use the old? Any tips as to removing everything to get ...

It's been a while, but I'm in the the market for a '00+ Supercharged Bonneville. Hoping to obtain one soon.........

I see a couple on ebay for around $1,000 up to $1,500. I'm kind of glad about that. But I'm hoping I can get it replaced or something for a little cheaper.

2 blocks, 2 miles... its about the same when your engine doesn't have any oil.

That sounds like clunking, not ticking to me. I'd guess that the bottom end is on the way out the door.
:stupid:

Not a good noise at all. And if it was an oil pressure issue, it would have been corrected when the ...

So I may be looking at possible repair or another engine?

man, I was hoping for a simple, easy solution like "just change your oil filter and everything will run fine." lol

Long story short, the car ran over a concrete stump and smashed the hell out the oil pan causing the oil to spill out. The car was drove about 2 blocks to be parked in a safe place to be worked on. After I replaced the oil pan I hear this ticking/tapping noise. http://www.youtube.com/watch?v ...