I think i will be able to make the long drive, HA-HA count me in!!

has the axle nut been off for any reason? i only ask cause it sounds like the same clunking noise i was having after changing both axles. another mechanic i know said to impact the snot out of it,,, no more noises at all. hope this helps.

Good evening to all,,

I have an Auto X-ray EZ scan 6000 scanner, and when i run through the operational data, it doesn't have fuel trims,,, it shows Block Learn and Integrator.

Can someone enlighten me to these two items?

Just so you know,,,,,

Block Learn shows 140ish

Integrator flucuates ...

The first ones i got were 17.5in in length,, thats why i had a hard time with them.

The shop will also recommend replacing the accumulator and orifice tube. That is also required for compressor warranty.

problem solved,,,

they were the wrong springs. the parts store said they were boxed wrong. so they ordered another set. they came in,, and they were the wrong hieght. they are suppose to be 13.19in and the ones i got are like 12in. so we are gonna try this one more time

Lets hope they get it ...

Hi to all,,
I started to replace my rear springs today, and i cant get the new ones to go in.
I have the FE1 suspension code, and i also have the spring codes of 8RW for left spring, and 9RW for the right one.
I got my springs from NAPA and they assured me they are the ones for my car, and i had ...

Is the resistor chip able to be removed.

I have bought two keys now off ebay,, first one was my fault,, read ohms wrong,, this new key has right chip, had it cut today and they didnt cut it right, and i dont think its saveable.

can i take chip from new key and put it in first key?

Thanks

Hey guys,,,
i know i said in an earlier post that i checked fuel pressure,
but i only checked it with key on engine off.
This w/end i checked it again.
KOEO-- pressure at 33psi
KOER-- at idle,, 40psi
" -- at 2500rpm,, 41psi
w/vacume disconnected at idle,, 45psi

does this sound like ...

I went with stock OE coils, since i dont have any significant mods.

Evening to all,,,

Sorry i havent gotten back sooner, but i think i have found the solution to my problem! :banana:

I have managed to replace all three of the coils, in the last month, nothing else.

Took her out for some quick runs today after work.

From a dead stop,,, stab throttle,,, no ...

changed the fuel filter a couple of weeks ago. same deal.

i guess pump replacement is in order. should i stick with stock,, or could someone recommend a good pump at a good price?

Thanks for the tip Alec,, I did check the FP today.
Key on, FP right at 34psi,, key off, dropped to 27 after about 5 minutes.
Wel, i guess i'll have to get one and see if it takes care of the problem. I'll post results later.
Everyone have a great night!!

How do you check the cat, without disassembling everything?

Hey guys,,
I replaced the 2,5 coil and it does seem to be better.
However, stabbing the throttle to the floor from a dead stop, it still seems sluggish until about 30mph or so.
Hooked autoXray 6000 scanner to it while i drove around, maf,tps,iat, iac and o2 looks good, however, i did have kr of ...

I was wondering about the cat. i'm sure it is original.
The o2 was changed about a month ago.

Yes, it does have the obd 1.5 but has the plug for obd2

Tomorrow i'll drive home from work with the scanner hooked up to see if there is any kr. it should read 0 correct?

I also have ohmed the coils ...

Oh I'm sorry,,, there is no CEL,,, and no codes,, other than P1565, for the cruise control servo position.

besides this little problem it runs great!!

averaging 18mpg city and 28mpg highway

Thanks

I bought the car last Feb, w/ 169000, I now have 176000, and have done the following,
uim/lim gaskets
head gaskets
major tune up,, w/
autolite xp606 plugs,, OE premium wires, (with loom around each wire), fuel filter, air filter, oil filter and oil every 3000 miles, and seafoam every third tank ...

Evening to all
Could anyone answer this question?
When i give the car fairly heavy throttle, from a light, it seems to be sluggish until i lightly let off the throttle, then it picks up like an ape on fire,, lol.
Does anyone have this symptom, and can point me to fix this, or am i alone?

Thanks ...

Hey all,,

first of all, i've had this problem now since i bought the car a year ago. I've also done all the checks that are suggested to be done to find the problem, i.e. tie rods, ball joints, struts, bushings, bearings, etc,etc. ( I've replaced the ties, (inner and outer), new tires, balanced ...