OK I have changed the o2 sensor out with a new ac delco one. I left the battery disconnected for 10 min and then reconnected it. The car starts up like normal. I drove the car all day and it did not shut off on me. I still dont know if this has solved the problem though. The service light still ...

So Ive called some Places about buying the o2 sensor most do not have the AC Delco brand, Two did and there were more expensive, one place wants 95$ and another wants 69$ Anyone know any cheaper places or is that just what they cost? Today i turned the car on and let it idle. Someone told me to look ...

So all 3 codes point to the O2 sensor? Is that what i should replace first? Also is there a link that you can point me too that shows me how to replace the O2 sensor step by step

Ok i checked the trans. Fluid the level was fine, the color was a nice clean pink/red color. I smelled it and it just smelled like Transmission Fluid to me. Not sure what i was smelling for tho. I also took the car to a small country shop and got them to run the codes for me. They said under the ...

Ok So i have searched and found nothing on how to Use the paper clip to pull codes off a 1994 Bon. SSEI. I found some on how to do it on a 1992 but not a 94. Any Ideas? I believe they are different but i may be wrong. I called autozone and they said they cant read codes before they year 1996 and to ...

OK guys i have no clue what is going on. Here are they symtoms. Ill start the car and it starts just fine. I drive the car for like a 15 to 20 min Drive and then it starts to act up. In higher gears going up hill the car is in low RPM and kindof of sputters or struggles to get up the hill. Sometimes ...

So I did the job. everything seems to be working just fine now. Thanks so much for all of your time. the old brake fulid was black in color and very dirty.

Okay I Got a new M/C and brake Fluid. Had one question tho. The new MC did not come with any Seals or O rings of any kind. Before i start doing this job i would like to know if there are any or do i just install metal to metal?

haha sorry guys for the misspelling i was in a rush at the time. Anyhow back to buisness. Where is the Brake M/C located? When doing a complete Flush what are the steps? Ive Bled the brakes on my old bmw, dont know if its the same? start at the (1)passenger rear, (2)drivers rear, (3) passenger front ...

So Guys my breaks are not working that well. If im sitting at a stop light after a few sec. the break pedal sinks in to the floor and i have to push the break pedal harder to keep the car from rolling. Also if im driving at speed and come up to a red light the same thing happens to the peddal at ...

So guys my car smells bad and leaks water everytime it rains :sad: So my carpets and headliner are water damaged. So i today started the job of redoing my headliner and finding the leaks. I started with removing the headliner and found that my sunroof drains are either disconedted or the drain pipes ...

This topic has prob. been discussed a million times, but i could not find it under search. Im trying to removing my headliner and reupholstering it. Im stuck with the sunvisors i cant figure out how to detach them or remove them. Pictures or detail instruction would be amazing.. thanks guys. Im ...

not sure if this is the Case. When i start off when the car is cold it hesitates, but not under breaking. when the car is hott it dose what i described above. anyway is there a way to unblock the Catalytic converter or check to see if this is the actual problem?

So my 94 SSEI cuts off sometimes with a werid idle.. This is what happens. as im driving down the road and i see a stop light i will apply the breaks slow and steady. The car slows and after a few sec. of breaking the car breaks harder without applying more force to the break pedal. As all this is ...

Haha thats funny you say that.. Because yes i was using a small screw driver and managed to pry one side out at the same time it smashed my hand. Luckly it did no harm. Me being stubborn went to the other side and poped that side out and sure enough the trunk fell down on me and yes it is very heavy ...

So my 94 SSEI trunk will not stay open. I looked underneath inside the trunk and the long bent rod on one side has broken/snapped. I went to a junk yard and found a rod that was still good and not broken, but i could not figure out how to take the rod off the junk car. Anybody done this job or have ...

So today i had a little time to mess around with these connectors and what i found out is that the seem to be wet/moist. no rust or anything really. It looked pretty good but both sides were kindof wet. Have not had time to go to junk yard to check out some there. Do you think if i put a blow dryer ...

Okay i called GM delarship and they said they cant find that part anymore.. they told me to take the wires out and just sauter all the wires going to that bus connetor together and that it would do the same job. Is this safe or what do u guys think.. Even better anyone know where i can find the ...

Ok im not really sure how to check the connectors. What am i looking for in a bad vs. good one? I also forgot to mention that when the windows dont work the power locks will not work either. Thanks for the replay

Hey guys i drive a 1994 ssei bon. well the other night i pulled my window down and it would not go back up. i check other windows to see if they worked and none of them move, so its not the window motor. i looked around for fuses, but all i find is a silver ciruit breaker. How do you know if thats ...