My whine ended up being the ac compressor pulley bearing.

Tps voltages were normal but the voltage would drop to zero and resume to its normal reading. Does this mean the tps is bad? The engine sometimes wants to stall. At idle the rpms drop but revs back up before it stalls. Also while driving the engine will stutter when cruisin at low rpms. Same thing ...

Not a harsh chugging. Just have to give some gas and quits. 1500 rpm and lower. Idles fine. Does stutter on start up occasionally.

What's up everyone. Hoping someone can help me with this. My 01 sle chugs at low rpms. No matter what gear im in. Its not constant either. Not every day but more often han not. whether I'm just takin off or cruisin at 55, it will chug. More like a stutter and I kno the ignition is good. The only ...

Well its shifting great now. Im sure if i did something wrong i would kno by now. first time doing this and when i was finished i got ti second guessin myself. thx for that link.

Ok. day 2. The downshifts are much quicker and at low rpms it shifts excellent. high rpms 2-3 good but the 1-2 is a lil slow. now i am still questioning if i did it right. theres a spring on top of the accumulator pistons. ones bigger than tje other. which one goes where? Just so i kno i got it ...

well, i installed the transgo shift kit in my 01 sle. i had hard shifting when hot. i really dont feel any difference. it no longer shifts hard. its faster shift when normal driving but if i give alotta throttle it still shifts slow and pops a code. i havent had the code read yet. it may not have ...

ok. ive replaced wheel bearings, ball joints, cv axle, rotors and pads. it only clunks when im turning right, either from a dead stop or a sharp turn. Can the struts do this because im pretty sure theres nothing left to replace that would make that noise. Appreciate the opinions! thx.

Ive been informed that this is the ac delco part# 87017816 lim gasket set.
Still would like to kno some mods for hp gain. I kno i cant get a lot. Just wanting to get the most out of it.

Wanting to get the aluminum LIM gasket for my 01 sle. My local parts stores dont carry them. I was going to order online, but I dont know the part#. Can anyone help me with this? thanx.

Ive almost finished with my 01 sle project. As far as new AC delco fuel and ignition systems. ive also replaced most of the suspension, brakes, maf,etc. I still need to do the uim and lim gaskets and then im ready for some mods.
So, Im looking and asking around and im wanting to get all the hp i ...

hello again. My 01 sle only blows hot or cold from driverside only. passenger side and rear just blow air. need some help with this. dont kno if its the dash unit or like a vent not opening or something. anyone kno how to figure this one out? thx.

well i think my stutter problem was a loose plug wire. #2 fell off the other day and i snapped him back on and hasnt stuttered since. ill still be watching it tho. my fault. thanx for the input tho!!
P.s. I hate front end suspension noises!!!

hey everyone. hoping yall can help as usual. i have an 01 sle. ive replaced the maf, iac, regulator, fuel filter, fuel pump, plugs, wires, and coil packs. all ac delco. after ive driven for a lil bit and shut the car off, when i start it back up it putters for about 3 seconds then runs fine. its ...

Just placed my whole order thru amazon. Got ac delco everything. shipping was only 45.00. I purchased 12 items and total order was 615.00. Thanx flatlander! good call.

just wanting kno the best brand. ive heard timken was good but what about the raybestos?

Just wondering if anyone can tell me which wheel bearings i should get for my 01 sle. Im purchasing an order from rockauto.com and theres a bunch to choose from. any help would be great. Thx.

good lookin bro. thx.

Awesome. thanx. What kit would you suggest? Ive never done any tranny work but fluid and filter change. do you kno where i can get installment instructions? any special tools or procedures? obviously i dont have to drop the tranny. Im liking that.

so i sont need to replace the pcs? Just put in a shift kit and im good to go?