Since I posted on here. Hope all the OG's are doing good as well as the newer guys.
Still have the Bonneville, she's still running good and strong.
In November I bought a 06' Yamaha R1, after building it to my likings, figured I'd throw up some pictures and video for sheets and giggles. Ole' blue is ...

I used either a 3/4" wrench or crescent wrench to remove it. You can lift the right front side, remove the wheel, remove the splash guard, wola. You can get to it better from this angle IMO.

06' Yamaha R1. May not be on here much, over at the R1 forums... seeya
http://i1149.photobucket.com/albums/o598/RogueSSEi/2012-11-20_18-37-09_573.jpg
http://i1149.photobucket.com/albums/o598/RogueSSEi/2012-11-20_18-36-22_956.jpg
http://i1149.photobucket.com/albums/o598/RogueSSEi/2012-11-20_18 ...

Anybody know what size the pressure tube is on the front? Smaller than 2.14 in. in diameter? I'm thinking about putting on a air bag system...

Srt8 FTW!

also, if i have to replace a cat are there any downsides to buying a universal fit cat. conv. opposed to buying a direct fit?
my local parts store has 2 different Magnaflow direct fits one for 169.99 and one for 398.99 and it says OE GRADE OBD II

Then the universal one is 87.99 and the other ...

Sounds like a bad cat

Welcome

Mine appeared that way also, after I degreased the bottom end real good, the problem was more apparent and when the oil is hot it will spread and make it look like other parts of the motor are leaking.

All is true, but a good rule of thumb is, if the transmission has never been rebuilt, put back in it what came in it from the assembly line.

I had a common problem, mine was a leaking oil pressure sender, I replaced and problem solved. Best advice, get some good degreaser, brake pats cleaner works excellent too, spray the area around where it is leaking, clean the whole area, take a test spin of 5-10 miles and this should narrow down ...

Valvoline high mileage DEX III ATF

I mentioned about painting some GP wheels awhile back, after sand blasting them (which revealed many bad pit spots) sanding the lip with a greaseless 80,220, then 320 and hitting it with Mothers mag and aluminum polish the lip turned out pretty good. In the pics are of a wheel taped up and hit with ...

If you don't mind me asking.... Where did you get the valve covers and are they a special 1 off design?

Sheeww that's sharp! Very nice

Welcome to the club.

Good looking Bonneville!

I'm thinking about rolling old school, some smoothies with baby moons and fat white walls.... It'd be something different. I have been looking at wheel vintiques smoothies, only thing is I would have to use a wheel adapter from 5x115 to a basic 5x4.5.... Dunno if I want that pressure on my hubs.

Will a 15" wheel fit on a 98 SSEi and clear the caliper etc?

In your proof on the car, does air leak?