Page 1 of 1

dashlight/ instrument lights blown?

Posted: Sat Aug 20, 2011 2:08 pm
by BFF_Larry
My Bonneville dashlights won't turn on when the headlight switch is pulled half way or either fully out. My voltage gauge light, that I mounted under the radio , went out the same time the dash and the lights for the a/c controls did.

I checked the fuses. They are fine unless the pinch tabs are bent or not in full contact


Any ideas?

Re: dashlight/ instrument lights blown?

Posted: Sat Aug 20, 2011 2:27 pm
by Bing
My guess would be the switch itself took a puke. Junkyard run or pay up the butt for new.

Re: dashlight/ instrument lights blown?

Posted: Sat Aug 20, 2011 10:17 pm
by BFF_Larry
i should of pulled one out when i was up there Friday. dang.

now my display for the a/c, heat isn't showing when headlights are on...

Re: dashlight/ instrument lights blown?

Posted: Sat Aug 27, 2011 4:05 am
by BFF_Larry
I checked all the bulbs in the instrument... None blown.

Replaced the headlight/ twilight part with one from a junk yard... Still working the same... Not instrument lights.

Oh I also replaced the entire instrument with one from a junkyard and no luck. Even the volt gauge light bulb is good but no power/ light.

I also just replaced the DIC with one tht was working.

Re: dashlight/ instrument lights blown?

Posted: Sat Aug 27, 2011 9:34 am
by atom
BFF_Larry wrote:I checked all the bulbs in the instrument... None blown.

Replaced the headlight/ twilight part with one from a junk yard... Still working the same... Not instrument lights.

Oh I also replaced the entire instrument with one from a junkyard and no luck. Even the volt gauge light bulb is good but no power/ light.

I also just replaced the DIC with one tht was working.

check graund bus- pass and driver
check http://cgi.ebay.com/ebaymotors/97-BONNE ... 2c5e2cb6a0
http://forum.detroit.in.ua/download/fil ... &mode=view

Re: dashlight/ instrument lights blown?

Posted: Sat Aug 27, 2011 10:30 am
by BFF_Larry
That was one of the first things I checked for corrosion. The connections were clean and looked basically new..

Thanks though for the link to the switch. And for your post.