Michigan Mega Meet! September 13th - 16th (read first post)

[petraman]

I'm debating on whether I'm leaving Friday or early Saturday... If I do leave Saturday, I'll most likely be there by 10am so I figure that most of you will still be getting your morning started. If I leave Friday, I'll probably be there between 8-9pm.

Oh also... Congrats Ryan!!!

[Wes]

I get out of work around 4, so I can probably be there between 6-7:00 on Friday.

I have been so busy lately, the olds is embarrassingly filthy. It can sure use a good cleaning. It will be good to finally get a chance to. It has seen quite a few 4 hour road trips these past few months, and I haven't cleaned it since.

Congrats on the little one btw!

[crash93ssei]

Honestly I am not even sure if I will have time to really clean any of my cars before the meet.... they are all very dirty and haven't been really cleaned that good all year. The last time the '03 was detailed properly was in my project thread in my sig (which I know, still isn't finished) Just no time for anything much lately

I will certainly use this weekend to do some detailing as well as let others take a swing on their own cars if they want.

[MattStrike]

I'm thinking I'll be arriving sometime between 9 and 10p Friday.

[yonkerse]

If my plan holds together, should be there around 8-9 pm on Friday!

[haro1225]

I'm going to try to get outta work as early as possible Friday so I should be there between like 6 and 8.

[Bad GXP]

Congratulations on the good news Ryan! Busy times ahead (very busy)

I anticipate my arrival Saturday after lunch, about 1:00 pending border crossing time and pit stops.

Thanks for the reminder about the lawn chairs and stuff, it's on my list of things to bring already. Present weather forecast seems to be calling for fair weather but a bit cool during the evening, (fire should come in handy) a light jacket would be a good idea.

Ditto for me too...excited for meet and greet.

[gweg_b]

Ugh, I had to get a nasty cold before this trip. First time I've been sick in almost 3 years. I'm going to try and snuff this thing out before tomorrow.

I also still need to go to storage and get my taillights off the Bonneville and find a fold out chair to sit on.

So much closer now!

[SSEiMan01]

I think I have three chairs at my condo and one here. If I can squeeze them in I shall.

[MattStrike]

So much closer now!

ARgh! I'm still not done putting wheels on my car! Don't remind me!

[WhiteArrow3800]

Jack the car up and mount your crosslaces backwards on the front, get the wheels spinning and grab a dremel. Eventually they'll clear the brakes!

[petraman]

Alrighty, I think I'm going to make it up Saturday morning... I'll be there around 10, though, so I hopefully won't miss all the festivities. Looking forward to seeing you guys again! (and looking forward to meeting everyone I haven't met yet)

[Wes]

Hey Ryan,

I would think you do, but just to double check, do you have a drain pan I can use to change my oil? Oh, and a bucket so I can run the old oil over to Murray's?

[crash93ssei]

Yes I have a drain pan. I will also be doing oil changes on both of mine as well

[Wes]

Good deal. I will throw some oil, and a filter in the trunk.

[repinS]

G8 goes in for minor surgery in the morning, having the front lower control arms replaced before I leave. Because of this, I'll now have a set of G8 LCA's at Ryan's that I no longer need. Any takers?

[SSEiMan01]

Which ones Jerry?

I'm holding out for Moog Problem Solvers. Yes they are working on them. They sound promising. (Benefits of being able to call on behalf of a *customer* as an AAP representative. )

[yonkerse]

Tomorrow at this time the group will be assembling!! Can't wait to meet everyone and see all the cars!

I will also be bringing some lawn chairs!

[repinS]

Which ones Jerry?

I'm holding out for Moog Problem Solvers. Yes they are working on them. They sound promising. (Benefits of being able to call on behalf of a *customer* as an AAP representative. )

GM revised set from Pace Performance. Is there an update to the situation with Moog? The last info I have is your post on G8Board saying that they may be working on them.

[MattStrike]

Trying to decide what tools I need to bring...