Supercharger snout pulley needs to be replaced
-
zvega88
- SE Member
- Posts: 14
- Joined: Thu Jan 19, 2012 11:35 pm
- Year and Trim: 2003 Pontiac Bonneville SSEI
- Location: TEXAS
Supercharger snout pulley needs to be replaced
For a little bit now i have heard this noise coming form the engine and we know its the pulley that is connected to the snout. I am wondering if there is a place where they sell the pulley by itself to replace it. Also any other ideas will be welcome too.
[b]THE KNIGHT RIDER[/b]
-
CMNTMXR57
- Certified Bonneville Nut
- Posts: 5841
- Joined: Wed May 13, 2009 10:45 pm
- Year and Trim: 2006 STS-V, 2004 GTO, 2009 G8 GT
- Location: CHICAGO
Re: Supercharger snout pulley needs to be replaced
Intense, ZZP, and probably a few others that have smaller Hi-po versions including a modular setup. Otherwise, GM sells them...
I don't think I have any of mine anymore.
I don't think I have any of mine anymore.
Retired Bonneville Owner and former GM Tech:
2004 Pontiac Bonneville GXP: Black/Ebony *SOLD*
Summer Toys: Combined 827 RWHP / 877lb/ft RWTQ
2004 Pontiac GTO: Impulse Blue Metallic/Black/M6: lots 'o mods, 415 RWHP / 405lb/ft RWTQ!
2006 Cadillac STS-V: Light Platinum Metallic/Light Gray/A6 - Spectre CAI, Magnaflow exhaust, Speed Inc. tune, 412 RWHP / 472lb/ft RWTQ
Daily Drivers:
2019 Chrysler Pacifica Limited: Mommy's new RGC
2015 Chrysler Town & Country Limited Platinum: Kids new RGC
2011 Camaro SS
2009 Pontiac G8 GT: L76, Sport Red Metallic
2004 GMC Sierra 2500HD: Victory Red - 8.1L Big Block and Allison
2003 Chevrolet Suburban 2500: Doeskin Tan - 8.1L Big Block... RIP
1999 Chevrolet Suburban: Sunset Gold Metallic - RIP
-
harofreak00
- Administrator
- Posts: 26022
- Joined: Mon May 19, 2008 6:04 pm
- Year and Trim: 2004 GXP - plus a handful of other Bonnevilles
- Location: Browerville, MN
- Contact:
Re: Supercharger snout pulley needs to be replaced
ZZP sells the stock 3.8" pulley for $10.
However, I guarantee that nothing is wrong with the actual pulley. It's either the snout bearings or the rotor bearings. Cheapest to just replace the SC.
However, I guarantee that nothing is wrong with the actual pulley. It's either the snout bearings or the rotor bearings. Cheapest to just replace the SC.
Andrew - owner/operator of Bonnevilles Unlimited
2004 Bonneville GXP | 60k | White Gold Tricoat | custom built supercharged 3800 hot rod | garage queen
1997 Corvette | 57k | Silver Metallic | Z06 wheels | Date-night Hauler/Parts runner
2014 Town & Country Limited | Cashmere Pearl | 115k | Family Hauler
2002 Ram 1500 Quad Cab Sport | Black| 280k | Official Bonneville Hauler
2004 Bonneville GXP | 60k | White Gold Tricoat | custom built supercharged 3800 hot rod | garage queen
1997 Corvette | 57k | Silver Metallic | Z06 wheels | Date-night Hauler/Parts runner
2014 Town & Country Limited | Cashmere Pearl | 115k | Family Hauler
2002 Ram 1500 Quad Cab Sport | Black| 280k | Official Bonneville Hauler
-
CMNTMXR57
- Certified Bonneville Nut
- Posts: 5841
- Joined: Wed May 13, 2009 10:45 pm
- Year and Trim: 2006 STS-V, 2004 GTO, 2009 G8 GT
- Location: CHICAGO
Re: Supercharger snout pulley needs to be replaced
My first question was going to be "did you check the S/C oil to see if there was any in there" figuring a bearing failure would be due to oil loss or high load on the snout, but figured I'd just answer the question.
Retired Bonneville Owner and former GM Tech:
2004 Pontiac Bonneville GXP: Black/Ebony *SOLD*
Summer Toys: Combined 827 RWHP / 877lb/ft RWTQ
2004 Pontiac GTO: Impulse Blue Metallic/Black/M6: lots 'o mods, 415 RWHP / 405lb/ft RWTQ!
2006 Cadillac STS-V: Light Platinum Metallic/Light Gray/A6 - Spectre CAI, Magnaflow exhaust, Speed Inc. tune, 412 RWHP / 472lb/ft RWTQ
Daily Drivers:
2019 Chrysler Pacifica Limited: Mommy's new RGC
2015 Chrysler Town & Country Limited Platinum: Kids new RGC
2011 Camaro SS
2009 Pontiac G8 GT: L76, Sport Red Metallic
2004 GMC Sierra 2500HD: Victory Red - 8.1L Big Block and Allison
2003 Chevrolet Suburban 2500: Doeskin Tan - 8.1L Big Block... RIP
1999 Chevrolet Suburban: Sunset Gold Metallic - RIP
-
zvega88
- SE Member
- Posts: 14
- Joined: Thu Jan 19, 2012 11:35 pm
- Year and Trim: 2003 Pontiac Bonneville SSEI
- Location: TEXAS
Re: Supercharger snout pulley needs to be replaced
Few months ago I filled up the oil for the SC but the noise keeps going. So im not sure what it is. When i put some WD 40 on the side of the pulley it stops the noise for few minutes but then it goes back again.
[b]THE KNIGHT RIDER[/b]