ABS & Traction stays on
-
Kevin Amstutz
- SLE Member
- Posts: 75
- Joined: Sat Aug 01, 2009 3:16 pm
- Year and Trim: 03 SSEI, 02 SSEI, 98 SSEI, 98 SSE, 98 SLE 98 SE
- Location: Appleton WI
ABS & Traction stays on
My 98 has the ABS and Traction control light that stays on. During intial key on, the ABS & traction light will not flash, steady on. Both of my wheel sensors are at 1050 & 1100 ohms, which are in spec. Max fuse on firewall and interior fuse panel is good. Any other ideas?
-
00Beast
- Retired Site Developer
- Posts: 20960
- Joined: Tue May 27, 2008 10:30 pm
- Year and Trim: '17 Silverado 1500
- Location: MN/IA
- Contact:
Re: ABS & Traction stays on
Check the resistance of the wiring to them. Being in WI, you could have a wire that's corroded through.
Bye Bye:
RIP sandrock
RIP sandrock
Sirius wrote:Think about it. You’re tooling down the road in your Prius, knowing full-well that this thing being green is as big a sham as federally mandated ethanol-enriched gas, Russia pulling out of Ukraine, and Obamacare.
-
Kevin Amstutz
- SLE Member
- Posts: 75
- Joined: Sat Aug 01, 2009 3:16 pm
- Year and Trim: 03 SSEI, 02 SSEI, 98 SSEI, 98 SSE, 98 SLE 98 SE
- Location: Appleton WI
Re: ABS & Traction stays on
The wheel end connectors back to the computer?
-
Kevin Amstutz
- SLE Member
- Posts: 75
- Joined: Sat Aug 01, 2009 3:16 pm
- Year and Trim: 03 SSEI, 02 SSEI, 98 SSEI, 98 SSE, 98 SLE 98 SE
- Location: Appleton WI
Re: ABS & Traction stays on
The manual says to rotate the wheel and check the wheel bearing connector end for 100mv. I put the car in gear to spin the wheels and with my Fluke meter set at the 300mv selection, both sides read 0 mv. I can't see any problems with the wires or connections. Anymore ideas?
Last edited by Kevin Amstutz on Sun Oct 03, 2010 4:15 pm, edited 1 time in total.