The last picture, the port i was wondering about is above the big hose on the boost control solenoid. I hooked a hose up to it( the one running across the engine) and plugged the end. I will just take that off and leave the port open. I put in a new tps and that code went away and rps seamed to ...

Thanks for the pictures. I got the map sensor hooked up, there is a vacuum hose connector on the top of the iacv on the front right side of the engine. I had that hose connected to the one that suppose to hook to the map sensor. Do you know where that hose needs to go or have a picture?

my ssei has been running poor and rough idel, the intake gaskets were out so i put those in, still idels rough, i have code po122 for low voltage to tps and code po107 which is for the map sensor. I dont think i have the map sensor hooked up, i have a white 3 prong connector i can figure out where ...

I run 91 octane gas all the time, plugs and wires are orriginal as far as i know. I picked up a new air filter, fuel filter and cleaner for the TB, going to try to get that done tonight and get plugs and wires tommorow. Dose a person need the platnium plugs? I will take a look at the dip stick ...

I have a 2000 SSEI, 81k it dont always start up on the first time, sometimes it fires but dies then it will start on the second try. It uses some oil betwen oil changes, i get 21 to 22 mpg driving 55-60. driving 70 dont seam to change it much, is that normal mpg? I think it should be better.