Alright so I started the drilling/tapping/and putting the timeserts in process yesterday. I got the left side of the block all finished. It's not that hard of a process, it's just time consuming.
http://i.imgur.com/ohgwVQh.jpg

Oh and here is what the guide dowels look like after about an hour ...

I've had this car for a few years- I parked it about 8 months ago when it started overheating and diagnosed it as a headgasket. Just recently I've been working on it at school doing the whole time-sert head bolt repair bs.

So far I dropped the cradle and motor and removed the heads

http://i ...

So I'm thinking about getting the flowmaster super 10s - the flowmaster super 40 delta flows are louder, but id like it to sound meaner. I was wondering if there would be any difference of running a one single in/dual out muffler with two pipes running out the back and running two actual mufflers?

Recently got about a foot of snow...wondering if I should take the intake out of the fender well and run a short ram type intake for the winter...has anyone had problems with snow/sand/salt being too hard on the filter in the fenderwell? our garage is heated..

I dont think it is a problem with the stereo tbh...I tested out the speaker wires of the speaker giving static and got a reading of 0 ohms...that is a problem right..?

The sound that my stereo is making is a really loud screeching type sound that is not affected by how loud or soft i turn the volume-it is always loud and it comes out of only the front left and rear door speakers. I tried different grounds to no success. :banghead: maybe it has something to do with ...

good news and bad - good- the new head unit powers on and makes sound. Bad- there is a high pitch static in the front left and the small rear door speakers...i tried rewiring the front left speaker wires and got the same result. I do have an antenna adapter which is hooked up so it dont think it is ...

Ok so I have three fuses that I will replace, the "audio (21)" "Instrument Panel (30)" and the "Dash Integration Module (38)" and hopefully this will fix my loss of lighting and audio from my first attempt...I also noticed that the number 63 fuse which is titled "Audio Amplifier" was not there at ...

Alright ill try to replace fuses and retry the connections tonight im stuck in school today :( im in northwest iowa near sioux center

When splicing into the cig lighter do you need to splice into the positive and the negative?

So i tried the setup you had with the GMO7b and i couldnt even get it to light up. I also must have blown a fuse or something because i now have no dash gauge lights and my stock stereo doesnt even work anymore. not sure what i did wrong..

I see thanks for the thread...So what wire will the new A3 wire connect to on the head unit's harness? there is a blue/white one available..

Yeah I hooked it all up with the old interface and the head unit lights up and everything but no sound. If I turn the volume all the way up I can just barely hear sound if I put my ear to the speaker. I'm now wondering if its a problem with wiring or if its the interface that doesn't work..

hello all. I recently bought a kenwood double din head unit. I'm wondering if i can use the C2R-GM32R http://www.sonicelectronix.com/item_8331_PAC-C2R-GM32R.html interface or if i need to get the GMOS 09 because of the monsoon amplifier(I am wondering this because i have a C2R-GM32R sitting around ...

do you just have to remove the outer cover to remove those corners?

right, im wondering if it would be easier just to but the intense FWI rather than making a custom one

I am planning on doing a custom fender wall intake to replace the stock intake. I found all the piping and clamps alright but I am struggling to find a proper air filter.. any suggestions? thanks

that thing looks super clean i like it- what kind of head unit did you put in there?

ah cool I see..did you sand the rims before applying or put any primer on?

Wondering what the best way to go about "blacking" out my tailights is - I like the charcoal color just want some input from someone who has done it