PontiacBonnevilleClub.com

hi fellow bonnies back again for another one!! There used to be pictures of how to replace a wheel hub on this site awhile back and i can't find it anymore . My car doesn't have abs so i don't know if is any different ???

Thanks Dan.I

Please tell us if it's a front or rear. Big difference.

When the weather warms up I am going to be doing my left front bearing. I can do pics and a quick how to if you can wait a week or so.

I'm about to pull my right front for my LSD install, which is why I asked. But again, without knowing front or rear, we can't offer a quick guide.

I just did mine tonight, but will hold off on posting any further until we find out if the OP is doing front or rear bearings.

Don't mean to "steal" this thread from the original poster, but I need to replace both front and rear wheel hubs on my 96 park avenue. From the little I know about Buicks and Bonnes they are alike in alot of ways. If I am right I would greatly appreciate a how to guide with pics.

Mechanic says he would charge me around $150 per wheel hub which is the only reason I haven't gotten it done yet.. The parts only cost about $45 each on ebay and if I could do it myself I would save alot of money.

Go ahead and start your own topic. The parts and procedures are identical between the bville and PA. We'll give you a list of tools and procedures.

You'll want either a GOOD air impact wrench or a very large 1/2" drive breaker bar for starters, as well as a T-55 (half inch drive) and a 34mm socket (also half inch).