92 wheel hub !!!

[brn2drm]

hi fellow bonnies back again for another one!! There used to be pictures of how to replace a wheel hub on this site awhile back and i can't find it anymore . My car doesn't have abs so i don't know if is any different ???

Thanks Dan.I

[willwren]

Please tell us if it's a front or rear. Big difference.

[Roadtech195]

When the weather warms up I am going to be doing my left front bearing. I can do pics and a quick how to if you can wait a week or so.

[willwren]

I'm about to pull my right front for my LSD install, which is why I asked. But again, without knowing front or rear, we can't offer a quick guide.

[Roadtech195]

I just did mine tonight, but will hold off on posting any further until we find out if the OP is doing front or rear bearings.

[wisemankw]

Don't mean to "steal" this thread from the original poster, but I need to replace both front and rear wheel hubs on my 96 park avenue. From the little I know about Buicks and Bonnes they are alike in alot of ways. If I am right I would greatly appreciate a how to guide with pics.

Mechanic says he would charge me around $150 per wheel hub which is the only reason I haven't gotten it done yet.. The parts only cost about $45 each on ebay and if I could do it myself I would save alot of money.

[willwren]

Go ahead and start your own topic. The parts and procedures are identical between the bville and PA. We'll give you a list of tools and procedures.

You'll want either a GOOD air impact wrench or a very large 1/2" drive breaker bar for starters, as well as a T-55 (half inch drive) and a 34mm socket (also half inch).