Page 1 of 1
99 Bonneville ABS light still on after replacing wheel beari
Posted: Sun Jul 15, 2018 4:56 pm
by wpbrink
Replaced rear wheel bearing as the sensor was bad... go to start car and ABS light still on. How do you reset the computer system to wipe out the abs light? New sensor tests good and lines going up to ABS control module are testing good. ..
Re: 99 Bonneville ABS light still on after replacing wheel b
Posted: Thu Jul 19, 2018 10:46 pm
by zuper8
If the new sensor tests good, there must be another sensor that's out. The light will go away automatically once there's no code anymore.
Re: 99 Bonneville ABS light still on after replacing wheel b
Posted: Thu Jul 19, 2018 11:45 pm
by J Wikoff
A vehicle has to move for it to test the sensors. You might have to unhook the battery for a minute to clear an active code.