Page 1 of 1
SWAP CULSTER LESABRE 1995 CUSTUM.
Posted: Wed Mar 22, 2017 1:29 am
by ELI
HELLO MY NAME IS ELI FROM ISREAL AND I HAVE LESABRE 1995 CUSTUM.
My car is no full of gauges, I know that in 1995 there was a model with full gauges, if I had a DIAGRAM wires of two culsters I could fit a full gauges to my car. If anyone has 2 wiring diagram that I would be happy. have seen On eBay the Connection is the same but I will not buy before I know for sure if the wires are right.
Thanks in advance to me.
Re: SWAP CULSTER LESABRE 1995 CUSTUM.
Posted: Wed Mar 22, 2017 8:13 pm
by RJolly87
This is the only documented swap that I am aware of, and it is on a 1993.
http://www.pontiacbonnevilleclub.com/fo ... 17178.html
It would be best to get the Factory Service manuals for your car. This is what they look like, however this set does not appear to ship internationally:
http://www.ebay.com/itm/1995-PONTIAC-BO ... 4R&vxp=mtr
In short, rewiring and adding wires is necessary for the swap to function. You will also need the module that contains all of the warning lights on the top of the dash that goes behind the Translucent strip with the Buick badge on it.
Re: SWAP CULSTER LESABRE 1995 CUSTUM.
Posted: Fri Mar 24, 2017 12:56 pm
by gmman
http://i281.photobucket.com/albums/kk20 ... 0374443534
http://i281.photobucket.com/albums/kk20 ... 0375743087
don't know if these prints are what you need. they are from my 95 BUICK PA normally aspirated with guage package.
Re: SWAP CULSTER LESABRE 1995 CUSTUM.
Posted: Fri Mar 24, 2017 2:09 pm
by RJolly87
Unfortunately that's not going to be it, but if you have the one with the pinout of the cluster connector, that could help greatly. Also, does this book cover both the C/H body buick, or just the C body?
Re: SWAP CULSTER LESABRE 1995 CUSTUM.
Posted: Fri Mar 24, 2017 8:53 pm
by gmman
the service manual that I have does cover c and h.
Re: SWAP CULSTER LESABRE 1995 CUSTUM.
Posted: Fri Mar 24, 2017 9:15 pm
by gmman
Re: SWAP CULSTER LESABRE 1995 CUSTUM.
Posted: Sat Mar 25, 2017 5:31 am
by RJolly87
I am not sure, it's posted out of context. I seem to remember there being a diagram of the connector itself at one point in there.
Re: SWAP CULSTER LESABRE 1995 CUSTUM.
Posted: Sat Mar 25, 2017 10:47 am
by gmman
will look again.
Re: SWAP CULSTER LESABRE 1995 CUSTUM.
Posted: Sat Mar 25, 2017 8:58 pm
by gmman
http://i281.photobucket.com/albums/kk20 ... 0492455165
R JOLLY
take a look at this page. I could get the connection, as an example, between B8 (OIL PRESSURE GUAGE INPUT FROM OIL PRESSURE SENSOR) and circuit 31. reference my earlier post of schematic for gauge cluster.
think this will help?
PS I think UB3 is gauge package. UB 2 (shown to the right of page) is likely what he has now.
