Page 1 of 1
Boost Gauge Tap on L36
Posted: Wed Aug 06, 2014 8:47 pm
by ChibiBlackSheep
What's the best place for me to tap for my boost gauge on my L36?
I have an Autometer SportComp2 sitting in a box and haven't gotten to throw it on my Monte yet haha
Re: Boost Gauge Tap on L36
Posted: Thu Aug 14, 2014 6:09 pm
by Backhoe
Im not sure on your L36 vacuum config, but I tapped in to the vacuum line at the firewall side of the motor close to the MAP.
Re: Boost Gauge Tap on L36
Posted: Fri Aug 15, 2014 2:05 pm
by Zeik75
ChibiBlackSheep wrote:
I must change my pants now.......excuse me.
Re: Boost Gauge Tap on L36
Posted: Sun Aug 17, 2014 3:45 pm
by Jfridge92
Holy crap they made a Paxton Novi kit for our cars??? Or did you fab that one up? Do you have a build thread?
Re: Boost Gauge Tap on L36
Posted: Tue Sep 30, 2014 8:08 pm
by redzmonte
Jfridge92 wrote:Holy crap they made a Paxton Novi kit for our cars??? Or did you fab that one up? Do you have a build thread?
That is a W-body. I think that was a ZZP kit IIRC. it could be adapted to fit a Gbody but not a direct bolt on.
As for the vac source, you can tap into pretty much any vac source on the engine.. If you only have a "Boost" not a "Boost/Vac" then you can tap right into the boost pipe.
FYI you can also use a Syclone/Typhoon/TGP AITS that threads into the boost pipe so that it doesnt pop out under boost.
S
