PontiacBonnevilleClub.com

Ok so I got this mps off a member here. How can I be sure what hub I have. I just bought a intence pulley and it does not fit.the hub is bigger than intence pulley? Any help appreciated ..

Pics would help.

Does this help

Looks like a smoothflow like I have. http://smoothflowpulleys.com/index.html

Only way to tell would be to take some measurements or to try someone else's pulley.

Looks like the machined Smoothflow to me.

After taking measurements smoothflow seams to be it. Now the question is who's pulleys can I use

Smoothflow's. They're the cheapest new anyways. He makes the pulleys for some other brands too, but idk if they are precisely the same...

Man I do wish I did some research before getting the intence pulley.
Well on thee good side someone will by this 3.5 for ccchhhhhheeaapppp!!

Man I do wish I did some research before getting the intence pulley.
Well on thee good side someone will by this 3.5 for ccchhhhhheeaapppp!!

Man I got to quit that
... sorry bout that double post.

You also need to spell INTENsE correctly.

Thanks for the correction ..... Atleast u new what i was trying to say.
If u could just follow me around and correct all my spelling that would be great. I really suck at spelling . Thanks

Just a update...


Ok so i took the advice of members and ordered a smoothflow pulley it just showed up here and this pulley is too big . Does any one have a smoothflow mps that coukd measure the hub so i can stop ordering the wrong one .. lol this is pulley #2... help guys
Any one no nate at smoothflow. I'm wondering if he excepts returns.... not so likly!!!

The best thing to do would be to measure the bolt hole spacing and ask whos hub you have.

The hub is one inch od. I have tried INTENSE and smoothflow . I have sent emails to nate at smoothflow as well as zzp.

IF I REMEMBER Correctly intense pulley hub hole was not big enough. and the smoothflow pulley hub hole is just a bit big.
WHO ELSE MAKES A MPS

I will toss this thing out and just by a new one.

IIRC Nate changed his design at one point. Could you possibly have one of his older pullies?

Did you buy your MPS from Larz01?

I will have to check. I think so. As far as the style size Hehopefully can still supply this..

Edit* after some research I got this system from zltful. I asked him if he got it from larz01.. I'm just ring to figure out who makes a hub that's 1 inch OD..


Ok

After talking with nate from smoothflow, we come to the conclusion that this is a first gen hub. I sent the pulley back to him and he will cut me an old style. Pulley.. so this time next week I should have my pulley back as well as my eBay headers... I hope my mods will support the 3.5.

JEzze wrote:Thanks for the correction ..... Atleast u new what i was trying to say.
If u could just follow me around and correct all my spelling that would be great. I really suck at spelling . Thanks

knew**** sorry had to lol

Correcting grammar in a year old thread? SMH...