Page 1 of 1

Aftermarket Gauges

Posted: Fri Feb 18, 2011 3:37 pm
by Shae
Hoping that someone could shed some light on my questions here.

on my 1992, I am planning (Once I have all repairs and maintenance done) to do some performance upgrades, and am interested in adding some guages, I have already got plans of fiberglassing a custom gauge pod, based on sugestions on this forum, mainly by willwren.

I'm intersted in adding a air/fuel ratio guage, and wondering if there are recommendations, and what is required in my car? Do i replace the o2 sensor i have with a wideband, or do i add a second o2 sensor.. etc etc.

Also a transmission temp gauge, again, any sugestions. Any other gauges I should think about adding?

I am very picky about one thing, they most match my car's dash illumination, no blue gauges or anything haha.

Re: Aftermarket Gauges

Posted: Fri Feb 18, 2011 3:43 pm
by Shae
I just realised, this should probably not be posted in this section, my bad

Re: Aftermarket Gauges

Posted: Fri Feb 18, 2011 4:25 pm
by willwren
Adding an AF ratio gauge on a stock or lightly modded vehicle is a waste of money. Either wide or narrow band. There's maybe 5 cars on this Forum that need one.

You don't have a voltmeter (alternator) gauge. Your boost gauge took that location. Do that and a trans temp gauge.