PontiacBonnevilleClub.com

you can use a dremel to cut behind the dash.. i used a drill and made holes all the way around...
make sure you watch for the cables behind..

I'll make a trip today if I get a chance, I looked at your install, so I just stuff everything down behind the plastic? It seems like the GMOS-09 won't fit back there.

nope GMOS-09 wont fit there... i have mine all the way down behind my heated control switches...

yeah it was a total bitch...

Darn i need to add wires then

No you don't need to add wires

I'm at work I'll explain when I get home...
All you need is gmos-09 that's all

Well I mean make the wires I have slightly longer, cuz I'm sure they won't reach, they're pretty short.

Not sure how short yours are but for mine all I used was the gmos with my stock wires... They can't be longer than needed other wise good luck tucking them in hahaha

Oh one question, should I have the subs out towards the trunk or in towards the seats? I put em in towards the seat cuz I put the system in for me... not everyone else haha

it's really up to you, i found that mind sound better facing away but every systems different.

swampthing wrote:it's really up to you, i found that mind sound better facing away but every systems different.

really? makes a difference even ina sealed trunk? didnt know that.. mine is facing out

Do you guys get a lot of trunk rattle? I don't like trunk rattle, and the subs are safer if I keep them faced in cuz I have stuff in my trunk. Oh and another question, what's the best Dremel bit(s) to use when cutting this gosh forsaken dash?

yeah it would be safer
my trunk barely rattles on the outside.. im really impressed.. my buddy with a mercedes C320 have the same system as mine and his rattles like shiit.. i hate it... you can barely hear my system when its blasted

as for the dash... i used a drilling bit lol as you can see in the pictures... but a good dremel bit would be the diamond wheel

Well, I used the wheel on the sides, but the drill is too big to fit to use the diamond bit for the top and bottom, unless were thinking of different bits.

sepenator wrote:Well, I used the wheel on the sides, but the drill is too big to fit to use the diamond bit for the top and bottom, unless were thinking of different bits.

so you done yet?

and use a battery powered drill if you have one.. itll do the job just fine

heres mine
then keep going all the way around

Dremel 561 is the bit you need. Cuts forward and sideways.

Thanks haro, and Samz, I should be done by the end of tomorrow night, depending on when sun down is, and how long my dremel battery lasts

yeah it took me a long time to get my system to work.. it was well worth it though...
now i added a sub and a rear view camera! its awesome!

Nice, I might do a camera down the road, not sure yet, but the subs are certainly making driving a lot more fun haha

Well, I'm all finished and as soon as I can find a camera, I'll post pics!

make sure you get something that shows a wide angle all the way around