Page 8 of 8
Re: Intak gaskets done and Running!!
Posted: Mon Jan 25, 2010 1:17 am
by willwren
You ran carb cleaner through WHERE?
Re: Intak gaskets done and Running!!
Posted: Mon Jan 25, 2010 1:35 am
by 94SilverSSEi
The throttle body, just took the rubber part off the air box and sprayed it in there
Re: Intak gaskets done and Running!!
Posted: Mon Jan 25, 2010 1:51 am
by willwren
Did you know carb cleaner is the worst thing you can do to your MAF sensor? Not only can it crack the plastic that protects the filaments, it can burn them out. You should only use 'sensor safe' intake cleaner on a fuel injected car.
You may have just caused more problems.
Re: Intak gaskets done and Running!!
Posted: Mon Jan 25, 2010 10:25 pm
by 94SilverSSEi
Idk. After I sprayed a BUNCH of cleaner through it. It seems to run very very good now. Also I put the bottom oring on the pcv but it didn't seem o have any effect.
Re: Intak gaskets done and Running!!
Posted: Thu Jan 28, 2010 5:15 pm
by 94SilverSSEi
Got it all done Saturday. Seems to run great now by my idle seems high. Like 1000-1500 in park usually around a thousand. Except on first start up it seems to sit at 1500
and in gear it stays a like 900
Re: Intak gaskets done and Running!!
Posted: Thu Jan 28, 2010 5:19 pm
by J Wikoff
Check for vacuum leaks (hissing) and perhaps a reason for the throttle body to not close all the way, like a mal-adjusted throttle cable.