Need help

Discuss your 2000-2005 Bonneville SE, SLE, SSEi, Buick Le Sabre 00-05 and Buick Park Avenue 97-05. Please use General Chat for non-mechanical issues, and Performance and Brainstorming for improvements.
Post Reply
Jnegrea93
SLE Member
SLE Member
Posts: 96
Joined: Fri Sep 26, 2014 3:45 am
Year and Trim: "00 ssei"

Need help

Post by Jnegrea93 »

What is symtoms of a bad fuel regulator? Sometime when I start my car it acts as if it's going to stall but catches it self and when I'm idling the rpms lower then raise no lower then half a grand and no higher the 1 grand. Sometimes it's hard to start until I press the gas.idont want to keep adding money and not fix the problem
User avatar
Archon
Resident Gearhead
Resident Gearhead
Posts: 8781
Joined: Mon May 19, 2008 10:30 pm
Year and Trim: 2014 Cadillac XTS Vsport.
Location: Grand Rapids, Michigan

Re: Need help

Post by Archon »

Often a bad fuel pressure regulator will cause hard starting. Pull the vacuum hose and check for a fuel odor in the hose. That would indicate a leaking diaphragm. It sounds as if your throttle body and idle air control valve could use a good cleaning.
*Gone, but not forgotten* - Black 2000 SSEi, HIR Headlights, Angel Eyes fogs, 3rd brake light overlay, hi-flo cat, 180 degree thermostat, HS 1.9 rockers, LSx yellow springs, Intense FWI, PCM, shift kit, push rods, and 3.4 Pulley. ZZP Power Log.
Jnegrea93
SLE Member
SLE Member
Posts: 96
Joined: Fri Sep 26, 2014 3:45 am
Year and Trim: "00 ssei"

Re: Need help

Post by Jnegrea93 »

Where exactly is the vacum hose for the fpr located?
User avatar
Archon
Resident Gearhead
Resident Gearhead
Posts: 8781
Joined: Mon May 19, 2008 10:30 pm
Year and Trim: 2014 Cadillac XTS Vsport.
Location: Grand Rapids, Michigan

Re: Need help

Post by Archon »

It's attached to the side of the FPR.

[The extension gif has been deactivated and can no longer be displayed.]

You could also check the fuel pressure, with the engine running. When you remove the vacuum line, the pressure should go up.
*Gone, but not forgotten* - Black 2000 SSEi, HIR Headlights, Angel Eyes fogs, 3rd brake light overlay, hi-flo cat, 180 degree thermostat, HS 1.9 rockers, LSx yellow springs, Intense FWI, PCM, shift kit, push rods, and 3.4 Pulley. ZZP Power Log.
Jnegrea93
SLE Member
SLE Member
Posts: 96
Joined: Fri Sep 26, 2014 3:45 am
Year and Trim: "00 ssei"

Re: Need help

Post by Jnegrea93 »

Is that the back or front of the motor? Sorry for so many questions
MrPOPE
SLE Member
SLE Member
Posts: 87
Joined: Sat Apr 19, 2014 8:02 am
Year and Trim: 2004 Bonneville SE

Re: Need help

Post by MrPOPE »

its in the front right on top up front....really hard to miss it
Jnegrea93
SLE Member
SLE Member
Posts: 96
Joined: Fri Sep 26, 2014 3:45 am
Year and Trim: "00 ssei"

Re: Need help

Post by Jnegrea93 »

thanks for the help
Jnegrea93
SLE Member
SLE Member
Posts: 96
Joined: Fri Sep 26, 2014 3:45 am
Year and Trim: "00 ssei"

Re: Need help

Post by Jnegrea93 »

The throttle body and stuff is all cleaned as it still does it. I had the starter, alternator and battery tested and they all came back good
mrrcom
SLE Member
SLE Member
Posts: 80
Joined: Mon Jan 27, 2014 5:41 am
Year and Trim: 2000 Bonneville SSEI
Location: Rockford, IL

Re: Need help

Post by mrrcom »

mine was doing the exact same thing. i thought was the crankshaft position sensor but that wasn;t the case. after i cleaned the idle air control it fixed the issue.

but ive read on here that the CPS gives simaler symptoms. its a semi cheap part but it involves pulling off the harmonic balancer
Jnegrea93
SLE Member
SLE Member
Posts: 96
Joined: Fri Sep 26, 2014 3:45 am
Year and Trim: "00 ssei"

Re: Need help

Post by Jnegrea93 »

I just replaced the crankshaft position sensor
User avatar
Archon
Resident Gearhead
Resident Gearhead
Posts: 8781
Joined: Mon May 19, 2008 10:30 pm
Year and Trim: 2014 Cadillac XTS Vsport.
Location: Grand Rapids, Michigan

Re: Need help

Post by Archon »

Did you also clean the IAC really well? Try removing it again, and pushing the pintle in some. Reinstall it, turn the ignition on and off, and then start. Did that help any? Have you tried it with the MAF disconnected?
*Gone, but not forgotten* - Black 2000 SSEi, HIR Headlights, Angel Eyes fogs, 3rd brake light overlay, hi-flo cat, 180 degree thermostat, HS 1.9 rockers, LSx yellow springs, Intense FWI, PCM, shift kit, push rods, and 3.4 Pulley. ZZP Power Log.
Jnegrea93
SLE Member
SLE Member
Posts: 96
Joined: Fri Sep 26, 2014 3:45 am
Year and Trim: "00 ssei"

Re: Need help

Post by Jnegrea93 »

I took the iac off today and cleaned it and my problem is fixed. Thanks for the help
User avatar
Archon
Resident Gearhead
Resident Gearhead
Posts: 8781
Joined: Mon May 19, 2008 10:30 pm
Year and Trim: 2014 Cadillac XTS Vsport.
Location: Grand Rapids, Michigan

Re: Need help

Post by Archon »

Great! Glad that it's fixed. Thanks for reporting back.
*Gone, but not forgotten* - Black 2000 SSEi, HIR Headlights, Angel Eyes fogs, 3rd brake light overlay, hi-flo cat, 180 degree thermostat, HS 1.9 rockers, LSx yellow springs, Intense FWI, PCM, shift kit, push rods, and 3.4 Pulley. ZZP Power Log.
Post Reply