the list for everything to work

[wiro01sle]

i want to put an aftermarket stereo on my car. but i need to knw every thing i need so every thin works properly. (onstar, chimes, streeing wheel controls). also where i can get the parts. thanks in advance

[BFF_Larry]

you have to find a hu that supports controls for steering wheels

[cammo87]

there is an adapter you can buy for the steering wheel controlls but the HU has to have a rf sensor..... aka it has to support a remote

[smittyingr]

Best buy sells a unit that retains steering wheel controls on any HU that has a jack in back of the unit for a wired remote and most units have that. Just go talk to the instal guys in back. The unit cost like $80 when I bought on for my old GP about 3 years ago. Go ask them the name and go find one online cheaper.

[00Beast]

The PAC Audio SWI-X is the harness for the wheel controls, IIRC. Turns them into a remote, IIRC.

[FireDevil]

Certain eclipse h/u have controls for sw built in. However its a 2 wire setup mostly for toyota/honda... the swix is about the only way to make them work and iirc it has a lil xmitter that covers the ir receiver. It works spotty. At best. (Unless theve fixed em since I was an installer)

Also, if you want chimes and onstar, you will need a gmos ribbon cable.. do you have an amplified system (bose)?

[wiro01sle]

I dont think its bose it doesnt have any badges like the trucks or suvs. so i need

[FireDevil]

You would want a metra 993301 or 992001 dash kit, a met gmos05 harness and iirc a metra 40cr10 antenna adapter to make everything work. That should retain chime with a non amped system