Yesterday I had cleared the codes out before I left work. I drove about 40 or so miles home with no mil. This morning about a mile down the road it came on. I drove about 1 mile or so to the school to drop off my kids, turned it off and checked codes. PO108. So, is it reasonable to assume that the ...

Over the weekend I had some time to mess with this thing. First, I found a vacuum tee with a big split in it. I replaced it hoping my problem would be gone. About 40 miles later there is the mil again. Same 2 codes 0122 and 0108. So I pulled the TPS took it to the bench, applied 5 volts to it and ...

Hi All, My 97 SSE is throwing out these 2 codes. P0121 TPS and P0108 MAP. On one occasion the idle went high by itself and would not return to normal until I shut the engine down. Started back up and it was fine. There does seem to be some intermittant hesitation from idle too. Other than that my ...

The ELC was not working at all. I haven't heard it in a couple of months. I was able to remove it. I took it too the bench and diss assembled it completely. It was completely locked up and the + brush on the motor burnt up. I am sure there is no way of getting parts for it??? The piston seal is bad ...

I have read a lot of posts about this but have not found what I am looking for yet. My in -trunk air compressor is not working anymore. I thought I remembered reading a post a while back about removing the unit, diss-assembling it, cleaning it and re-oiling. I am not exactly sure where the thing is ...

I'm going with one (or more) of your tires has an issue. I put 4 new Dunlops on my 97 just after I bought it and had the same problem. I kept taking it back for re balance, alignment, inspection etc. After about a year of dealing with it I took it to the same place to get a free rotation and they ...

Well, for about a week now my baby quits running at 1/4 tank. When I go to fill it up it takes about 5 gallons less than before so I know the tank is not going all the way empty. I changed the fuel pump over a year ago and this has just started. I was pretty perplexed when I got between 3/8 and 1/4 ...